Establish Link
connect the camera to the computer
First connect the camera with the computer
using the parallel port (or USB or Ethernet)
and connect it with the power supply.
This program supports only SBIG cameras using the parallel port, USB or Ethernet.
Then start this program.
If the camera is found, this is shown in the status line,
if not, an error message is shown.
Then the program uses the values of a ST-7, but only for informational propose.
To Establish Link use : Camera- Establish Link.
If that does not work, change the settings for the parallel port,
USB or Ethernet at: Camera- Settings Computer.
Settings Computer
Change the values of the parallel port (or USB or Ethernet)
and try to Establish Link again.
Or try: Camera - search camera